Contraband Detector

CDS-2002i™ CONTRABAND DETECTOR

The CDS-2002i™ Contraband Detection System provides "x-ray vision" for law enforcement professionals enabling detection of contraband hidden within areas such as automobile tires, doors, fenders, bumpers, fuel tanks, as well as aircraft structures, boat hulls and building walls.

Applications
The CDS-2002i is used to detect concealed objects and materials including weapons, narcotics, alcohol and explosives. As the suspect object is scanned, contraband materials reflect the low-level radiation, which is measured by the very sensitive detector. The operator is alerted by both a backlit digital display, visible in all light conditions, and an audio beep that increases in rate as it detects more contraband material. Different sounds indicate the relative density of the contraband detected and indicate probable drug or gun type materials. Each unit may be calibrated against a standard, assuring consistent performance from unit to unit.

Features
The CDS-2002i is a lightweight, hand-held system that utilizes a microprocessor, a self-contained low-level radioactive source, and a sensitive detector to measure backscatter through solid surfaces. The CDS-2002i operates on standard 9-volt alkaline batteries that provide 18 to 36 continuous hours of operation.

Benefits
The CDS-2002i is a powerful and reliable portable hand-held device that can be operated in virtually any setting. It provides a low-cost and time-saving method of detecting contraband in materials that are too difficult or time-consuming to inspect by hand.

CDS-2002i™ Contraband Detector
Technical Specifications

Performance
Radioactive Source	Ba-133, working life 15 years
Source Strength	100 µCi (Standard) or 10 µCi (Exempt)
Fuse	1/4 Amp, 250 Volt Subminiature
Battery	9-Volt Alkaline, commercially available
Current Drain	15mA without backlight, 30mA with backlight
Counting Method	- Mode 1 - Direct counts divided by 100 - Mode 2 - Standard Deviation of count value stored when mode 1 was exited - Mode 3 - Difference in actual counts and stored value
Radiation at surface	Unit On: 5.4 mR/hr, maximum
Dimensions	7.2" x 2.0" x 3.0" (18.3 x 5.1 x 7.6 cm)
Weight	2.6 lb. (1.2 kg) with battery
Finish	Anodized Aluminum, black
Switch Functions
Mode	Changes modes. Current mode indicated on front panel LED.
Lamp	Turns on/off LCD backlight.
Hold	Freezes display, micro-controller does not process any data when "Hold" is active. Indicated by flashing the current Mode LED.
Front Panel Display
Mode LEDs	The mode LEDs show the current mode setting. If the LEDs are blinking, the unit is in "Hold".
LCD	The LCD (Liquid Crystal Display) shows the current counts (scaled) or the Standard Deviation from the stored count value.
Warranty	1 year parts and labor.
Disclaimer
Due to our efforts to continually improve the system, specifications, dimensions, and operating procedures are subject to change. All specification and measurements are approximate, based on the normal configuration of the system; results may vary with the installation, application and environment.